|
|
 |
 |
 |
| |
 |
Cylinders Series 60 |
 |
Single and double–acting (magnetic) (DIN/ISO 6431)
Bore: ø 32, 40, 50, 63, 80, 100,125 cushioned
[1 1/4”, 1 9/16”, 2”, 2 1/2”,
3 1/8”, 4”, 5” inch approximations]
|
The Series 60 cylinders with diameters 32,
40, 50, 63, 80, 100 and 125 have been
designed to comply with the dimensions laid
down in the DIN/ISO 6431 standards. A
removeable magnet is mounted on the piston
in these cylinders.
This cylinders series is normally equipped
with adjustable end–stroke cushioning.
Moreover these cylinders are equipped with a
mechanical cushioning in order to reduce the
impact of the piston as it reaches the end of
the stroke.
These cylinders can also accommodate stroke
lengths up to 1000 mm for bore sizes shown
in the table.
|
|
|
|
|
|
|
|
 |
Single, double–acting, magnetic (DIN/ISO 6431)
Bore: ø 32, 40, 50, 63, 80, 100, 125 cushioned
[1 1/4”, 1 9/16”, 2”, 2 1/2”,
3 1/8”, 4”, 5” inch approximations]
|
The Series 61 cylinders with diameters 32, 40, 50,
63, 80, 100 and 125 have been designed to comply
with the dimensions laid down in the DIN/ISO 6431
standards. The extruded aluminum tube with
improved aesthetics, has two grooves (on three
sides) where the proximity switch Mod. CST can be
directly mounted. This enables the same cylinder
dimensions to be retained.
Four tie–rods located inside of the tube make the
mounting of the end–blocks extremely secure.
This cylinder series is equipped with adjustable
end–stroke cushioning. Moreover, these cylinders
are also equipped with a mechanical cushioning in
order to reduce the impact of the piston as it reaches
the end of the stroke (only until ø100).
The cylinder series can also accommodate stroke
lengths up to 1000 mm for bore sizes shown in the
table.
|
|
|
|
|
|
|
|
|
 |
 |
 |
|
|
|
