Series 6PF Positioning Feedback cylinder

September 17 2013

Precise position control

Aiming to increase both precision and control in the actuation resulted in the development of the new pneumatic actuators Series 6PF.

In compliance with the ISO 15552 standards, they are equipped with a potentiometric transducer of a linear position integrated inside the rod. This type of cylinder makes it possible, along the entire stroke, to constantly control the position of the rod.

The sturdy design, the flexible installation and the high performance render these cylinders suitable for use in applications such as: tensioning cylinders, positioning cylinders and filling, cutting and measuring systems.

Standard cylinders, to ISO 15552

The cylinders Series 6PF comply with ISO 15552 standards and can be assembled with the entire range of standard accessories.

Available sizes and strokes

Cylinders Series 6PF are available with bores from 50 mm to 125 mm with standard strokes from 50 mm to 500 mm with intervals of 50 mm.

Low Friction

The pistons of the Series 6PF are equipped with specific seals for low friction.

Use with external end-strokes

Besides having the constant control of the position by means of the transducer, the piston has been equipped with a permanent magnet in order to use external end-stroke sensors.

Electrical connection

Thanks to the electrical connection, realized by means of an M12 connector positioned on the rear head, these cylinders fulfil the standards of IP67 protection class.


> Protection class IP67
> Low friction
> Secure and precise position control > Robust Design
> Assembly with standard ISO accessories

Visit 6PF Catalogue page